Jaguarjx2
NAXJA Forum User
- Location
- Joliet, Il
Ok, I have read dozens of posts on here about cams but none comparing these two. So my question is, which cam would you recommend (preferably from actual experience). This is for my 2000 jeep Cherokee 4.0, bored 30 over with a 0630 mildly ported, stock valves and magnum springs. port matched intake and aftermarket header. 62mm throttle body. It has a 4.5" lift with 4.10 gears and a aw4 attached.
As a side note, engine was rebuilt with a 0331 head and the 68-200-4 cam but feels under powered. I plan to tear into it and check the cam timing and am planning on porting 0630 head I have and toss it in. Which is where I am debating on swapping out the cam as this will be the time to do it.
As a side note, engine was rebuilt with a 0331 head and the 68-200-4 cam but feels under powered. I plan to tear into it and check the cam timing and am planning on porting 0630 head I have and toss it in. Which is where I am debating on swapping out the cam as this will be the time to do it.