Dana 44 UCA bushing

I've got a waggy 44 front that I snagged 2nd hand from a fella and its got the RE bracket kit on it. I need to replace the passenger side UCA axle end bushing. The problem is that it doesn't seem to be stock, the bolt is the stock 10mm (roughly 0.4" as listed on napa and others) and the metal sleeve ID is just over 0.5".

The kit takes Dana 30 UCA bushings, so does anybody know of a dana 30 UCA bushing with a 0.5" ID sleeve?

If its an RE kit, it will be a bushing from RE. I would call them, they will have it, or at least point you in the right direction.

it either uses a stock UCA bushing or the small super ride one. if the ID is jsut over .5", its probably jsut been stretched out

http://www.rubiconexpress.com/Jeep/XJ/Product.aspx?part=RE3784

More likely your measuring the ID at the ends of the bushing!But if you look down into the middle you will see some raised "tits" that bring it back to 10mm.

I should have included this in my original post:
I had called RE before I even posted and they told me they should be stock sized
It's not stretched out, the sleeve is tight, and the tits are still in there, it wiggles even with the tits

I did find this and it seemed to mention my issue: http://naxja.org/forum/printthread.php?t=7418&pp=30

Took a video so you can see what I'm talking about; by posting I was just trying to see if anyone had come across this issue before:http://www.youtube.com/watch?v=tMcnf3tQqj4

any idears?