• Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.

i need help with my 88 XJ

O

onyx maximus

NAXJA Forum User
Location
Oregon
i have a 1988 XJ pioner and im putting on a cheap 3in lift using spacers and blocks and the only thing holding me back know is the bump stop ive been trying to get off for 2 days, ive tryed to pull it out, beat it out, and i just ont come off and i dont want to cut it off, so does any one know how to take it off
 
front or rear?

am I reading that right... 3" blocks and 3" spacer?? ouch.
 
well why do you need to remove the bumpstops up front?

the spacers should slip over top same way the coils did. to add bumpstop, bolt some hockey pucks to the axle spring mount.
 
Like I said on the other thread pipe wrench. Have you tried PB blaster? how about heat then cold water then heat, back and forth till it breaks the rust loose. I got that one in mexico from a guy working on our trailer with a oxy propane setup. It worked better than we thought it was going to.
 
You must log in or register to reply here.

Similar threads

T
XJ shackle with custom springs question.
Replies
11
Views
208
XJlimitedx99
X
I
Bought Son 2000 XJ, Need Help with RC Lift
2 3
Replies
45
Views
6K
Tim_MN
Tim_MN
C
Looking for Wiring Harness for 2.8 to 3.4 conversion
Replies
0
Views
57
CaptainSteve23
C
Bobthejeep
need help replacing shocks
Replies
4
Views
103
Ol Blue
O
R
Which steering box brace? Bearing or not?
Replies
7
Views
379
75SV1
7
Back
Top