pb_beaker
NAXJA Forum User
- Location
- in a van down by the river
Well i got a used but new skid plate and thought it would be a simple install. However i neglected to pay attention and i have spacers on my cross member. I also saw that the t-case was lower and hitting.
So i looked for what could be causing that and the trany support looks ok but this is what the driver side motor mount looks like. The pass. side is cracked all the way through.
Heres my questions.
Is it bad to drive it the way it is, with the engine mount and t-case the way they are?
What else would cause the t-case to drop like that?
and Is that skid plate not going to work?
So i looked for what could be causing that and the trany support looks ok but this is what the driver side motor mount looks like. The pass. side is cracked all the way through.
Heres my questions.
Is it bad to drive it the way it is, with the engine mount and t-case the way they are?
What else would cause the t-case to drop like that?
and Is that skid plate not going to work?