xj_mike
NAXJA Forum User
- Location
- San Diego, CA
This is a like new condition, Snap-On Blue Point plasma cutter. Very low hours (maybe 12-15 hours). It works great on 1/8" plate and thinner metal. 3/16" it works well and will do 1/4" but is getting to its limits. It runs on 110 volt AC, 20 amp circuit. It has 4 extra tips and nozzles.
It is a "contact" start meaning you push the button and press the nozzle down on the material. You lift just slightly and it starts the plasma arc. Once you get used to it, no issues but it's not the same as newer models with the instant start.
Only reason it was replaced was due to us needing to cut 3/8" plate which this will not do.
Price $600.00 (shipping and packaging extra)
Perfer local pick up in San Diego but will ship if buyer pays shipping and packaging costs. Email [email protected] Thanks for looking.
It is a "contact" start meaning you push the button and press the nozzle down on the material. You lift just slightly and it starts the plasma arc. Once you get used to it, no issues but it's not the same as newer models with the instant start.
Only reason it was replaced was due to us needing to cut 3/8" plate which this will not do.
Price $600.00 (shipping and packaging extra)
Perfer local pick up in San Diego but will ship if buyer pays shipping and packaging costs. Email [email protected] Thanks for looking.
