-
Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.
What axle shaft can go in a dana 30?
- Thread starter curbdog17
- Start date
- Location
- Houston, Tx
You can use a shaft from any:
XJ
TJ
ZJ
WJ
MJ
Dana 30 assuming its a non-disco.
XJ
TJ
ZJ
WJ
MJ
Dana 30 assuming its a non-disco.
MoparManiac
NAXJA Forum User
- Location
- Amherst, NH
I believe some 84-86 XJs used CV shafts instead of u-joint shafts. All 95+ XJs have 297x shafts, while most others (unless they have abs) used 260x shafts. All bolt in.
All TJs use 297x shafts. All bolt in.
Don't most ZJs use CV shafts? I know there are some with u-joint shafts (should be 297xs?). All bolt in.
I'm 99% positive WJ D30s are wider and always used CV shafts. I don't think these can be used.
MJs are pretty much the same as XJs. All bolt in.
Matt98XJ
NAXJA Forum User
- Location
- Sanford Stadium, row 5.
WJ shafts are longer.
hanaxj87
NAXJA Forum User
- Location
- Cincinnati,Ohio
I like the ZJ CV Shafts...
Nick
Nick
WB9YZU
NAXJA Forum User
- Location
- Madison, WI
If this rig is used Off-Road, I suggest you go alloy. TJ shafts fit.
cherokee chuck
NAXJA Forum User
- Location
- freeland,wa usa
I like trashy women, but that doesn't mean they're worth a damn . C/V joints are a a weak link if you offroad at all. Just my opinion though.:cheers:
emr1101
NAXJA Forum User
- Location
- Raleigh, NC
alloys are $500+, id run some stock shafts with 760 joints
Just Differentials
Differentials and Axles!
- Location
- Washington State
If going to a junk yard stick with 95+ xj or TJ so you can get the larger joints. Better yet upgrade the shafts to some chromoly. We offer them as kits, OE replacement assemblies, or individual chromoly as well.
