ebyrd10000
NAXJA Forum User
- Location
- Phelan Ca
I have a 99XJ with a RE 4.5 superflex lift i want to run 33" tires and minimal cutting if i run 33x10.5x15 would I need to cut i have 31x10.50x15 now and have no issues?
-
Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.
Re 4.5 lift
- Thread starter ebyrd10000
- Start date
x2elite
NAXJA Forum User
- Location
- Texarkana, AR/TX
I ran 33-12.50-15's on 15x8 wheels with 3.75" of backspacing on my RC 4.5 for about 6 months without any rubbing issues at all. Now I run 35's on my RC 4.5 with Bushwacker flares, and they are on 10 inch wide wheels..
RCP Phx
NAXJA Forum User
- Location
- Phoenix,Az
Unless you bumpstop like crazy(and then whats the point),they are going to rub.This is 6" of RE springs w/ 33x10.5's.Notice trimming in the front and still a dent.This is with LA's,shorts arms will be even worse.The rear is fully stuffed and rubbing also.I have 4.5" of bumpstop in it!ebyrd10000 said:
Last edited:
x2elite
NAXJA Forum User
- Location
- Texarkana, AR/TX
Just bumpstop it accordingly and you will be fine.
Tampa_XJ
NAXJA Forum User
- Location
- Detroit, MI
depends on your wheeling...for light to moderate wheeling you'll be ok with some fender trimming...you'll rub under full stuff, but otherwise should be fine... If you are a hardcore rock crawler, then you better go higher. I'm running 4.5" with 33x12.5s and I had to do a little fender trimming and raise up the stock flares. Only time I get rubbing is under full flex.
