Window Regulator replacement

Anyone know where I can find instructions?

I searched but to no avail

Thanks in advance

Did you find a regulator?

You'll need to drill out the rivets which hold on the existing regulator.

You'll either need a large rivet gun or small replacement bolts for the new regulator.

===

I'll see if I can dig up some instructions 4 U.

===

Thanks.

I'll be fixing this next week. Just found out it's on back order.

AND IT'S SNOWING LIKE HELL WITH NO WINDOW.

Download THIS and look at page 1382.

Download THIS and look at page 290.


From the FSM (sorry, no pics):
1) Raise window half way up. Disconnect battery negative cable. Remove door trim panel and water shield.
2) Insert a drift punch into hole in door inner panel, or use masking tape to hold window half way up. Remove regulator arm retainer clip, and remove arm from bottom window channel.
3) Disconnect wires from motor. Remove inner door panel-to-regulator nuts and bolts. Remove regulator and motor assembly.

Installation: To install, reverse removal procedure.

While you're waiting for the new regulator, you can disconnect the current one from the window and then just push the window up.

Then use masking tape all around the inside and outside edges to hold it in place.

.