what should my CA lengths be?

Mopar It · Jan 21, 2008

i have rough country short arms upper and lower adjustables with 4.5" coils and 2" spacers. don't remind me that it won't ride good yadida yadida i heard it i just need the thing drivable for now, i need my coil spring centered with the bumpstop like | U | before they were like \U \ so if anyone has the proper lengths, thatd be great, thanks.

mustangconv85 · Jan 21, 2008

here are the measurements from my RC 6.5" kit straight from the RC instructions

10. Remove the stock lower control arm from the axle bracket and the
nut and bolt from the frame bracket, doing one side at a time.
Lubricate bushings with a lithium grease or equivalent and install
the new bushings and sleeves in the Rough Country control arm.
Adjust the Rough Country adjustable control arm to a
measurement of

16 ½” from center to center and install on the
vehicle using factory hardware – do not tighten at this time. See
Figure # 2.

11. If equipped reinstall the ABS sensor wires using the original
hardware.
12. Remove the stock upper control arm by removing the factory
hardware from the axle bracket and then removing the nut and bolt
from the frame bracket doing one side at a time. Do not remove the
factory bushing in the axle mount –it is reused. Lubricate bushings
with a lithium grease or equivalent and install the new bushings and
sleeves in the Rough Country control arm. Adjust the upper Rough
Country adjustable control arm to a measurement of

15 ½” from
center to center and install on the vehicle using factory hardware – do

not tighten at this time. See Figure 3.

Mopar It · Jan 21, 2008

thank you very much, so 15.5 uppers, 16.5 lowers. any advice on whether to mount the uppers first or the lowers?

what should my CA lengths be?

Mopar It

NAXJA Forum User

mustangconv85

NAXJA Forum User

Mopar It

NAXJA Forum User

Similar threads