• Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.

T-case swap

supsa

supsa

NAXJA Forum User
Location
seattle
So I have a 231 J with a 21 spline count that I need to replace with my 231j with the SYE and 23 spline. So my question is how hard is it to replace the splines. I need the SYE t-case to be 21 spline and don't want to damage it by pulling it apart
 
Will the spline just come out after unbolting it or is there a trick
 
u have release the whole planitary gear set up and then a lock ring holds the input shaft to the planitary gears
 
Sounds eazy enought. Thanks.
 
Slo-Sho said:
Get yourself some good snap ring pliers, if not you're going to be in for a real treat.
Click to expand...

HES NOT KIDDING!

i had a crap pair and all i did was :banghead:
 
It would be alot less work to just swap out the SYE!
 
Umm...are you aware what a 'spline' entails? Splines cannot be removed or changed out...etc, etc


Jim
 
You must log in or register to reply here.

Similar threads

O
SYE vs Fixed Yoke spline geometry
Replies
7
Views
3K
RCP Phx
R
B
Dana 30 arb locker question.
Replies
13
Views
229
Bmfinney
B
M
NP 231 input shaft
Replies
3
Views
2K
RCP Phx
R
D
T-case sensor- same for 231 or 242?
Replies
8
Views
2K
DPG
D
E
SYE manufacturers....I can't find a clear answer.
Replies
9
Views
432
Trouble
T
Back
Top