Did it bend?

I'm having a brain fart today. I can't tell if I bent my Rubicon Express tracbar: RE1660

I for the life of me can't remember if this bend was there or not



I'm getting a little groan when I turn from full lock to full lock while parked. I'm thinking it's the superflex joint on the top end of the tracbar, but I haven't had a chance to have someone sit in there and crank the wheel while I sit down there and look to see what it is.

I doubt you bent it. I'm sure the powdercoat would be chipping off or something if you did.

mine same look,not bend,

That's damn impressive. I launched the thing like 2-3' in the air and came down HARD. Whoops :\

gregmondro said:

That's damn impressive. I launched the thing like 2-3' in the air and came down HARD. Whoops :\

Click to expand...

Hows your front axle after that? it doesnt look like you have a truss

I don't. I was afraid that the housing might just be bent, but it looks like the only thing it did was mess up the alignment. I'm replacing the lower control arm bushings and then taking it to get aligned asap

I've bent mine (the 1600), and the front end has never been off the ground. That upper bend just kept bending. (and no, the powdercoat didn't flinch).