am i wrong?

Jeepm@n

NAXJA Forum User

Location

Northern, WI

• Oct 14, 2007

• #1

Ok my 96 Xj I bought needing work and ended up running out of money. Thanks to medical problems. Anyways I was looking it over and found what looks like the upper control arm is upside down on the drivers side. It was replaced by the PO and is sitting with the U facing up. Where all the other arms have the U facing down. Do i need to change it? It is not being driven due to needing a bumper and stock springs as the PO did not finish the 4.5 lift kit and the lift is to go on my 94.

 

w_howey

NAXJA Forum User

Location

The Mudwest

• Oct 14, 2007

• #2

Yes, its upside down.

Its been broken loose already, go ahead and put it the way its supposed to go.

 

Jeepm@n

NAXJA Forum User

Location

Northern, WI

• Oct 14, 2007

• #3

Thank You W Howey. I want it done right good thing i looked closer at them lol.

 

O

outlander

NAXJA Forum User

Location

Columbus,Ohio

• Oct 14, 2007

• #4

damned p.o's....

 

Jeepm@n

NAXJA Forum User

Location

Northern, WI

• Oct 14, 2007

• #5

LOL outlander

 

Starboard M

NAXJA Member

NAXJA Member

Location

Lafayette, CA

• Oct 14, 2007

• #6

How can you mount it upside down? The upper control arm bushings are on the axle side, right?

So how would one be able to attach the control arm then?

 

UNCC_99XJ

Twisted Up

NAXJA Member

Location

Harrisburg, NC

• Oct 15, 2007

• #7

Can you take a picture of this? Having a hard time picturing it in my mind as well.....

 

Comanchedude

NAXJA Forum User

Location

Cincinnati,Ohio

• Oct 15, 2007

• #8

Starboard M said:

How can you mount it upside down? The upper control arm bushings are on the axle side, right?

So how would one be able to attach the control arm then?

Click to expand...

I was thinking the same thing