H&T leak

Hi all,

I am leaking atf from the end of the output shaft even after cleaning it up and sealing it with rtv. I would like to place a sealed bearing in place of the open output shaft bearing.
After all of the searching I was wondering if anyone has done this and has the part number of the bearing?

Thanks,
Dave

have you tried to just swap the seal instead of using rtv?

Yes. The leak is coming from between the splines. I dont see any need for there to be fluid back there so a sealed bearing would work. I have read threads where it was mentioned but no follow up as to whether or not it was done or a part number.

Thanks,
Dave

if just the seal doesn't fix the problem then you have a bad bearing in there that also needs replaced.