BIgDaddyChia
RRC Organizer
- Location
- Round Rock, TX
Just wanna make sure its the ZJ front right. It will bolt right up??
Last edited:
-
Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.
Which driveshaft can
- Thread starter BIgDaddyChia
- Start date
KarlVP
NAXJA Forum User
- Location
- Hardcoreville, WA
No the ZJ front is only compatible with the wacky ZJ flange yokes.
KSXJ
NAXJA Forum User
- Location
- Kansas City
more info. Rig specs, SYE? bolt up for what application. The ZJ front shaft is longer than an XJ front shaft.
BIgDaddyChia
RRC Organizer
- Location
- Round Rock, TX
sye 3.5 inch lift Sorry I realized after i posted this and left I forgot to do the question. I am trying to find a cheap way to do a rear drive shaft its a 231
Georgia Mike
NAXJA Forum User
- Location
- Flowery Branch,GA
I used a ZJ front driveshaft for my rear. It wasn't a full-time 4 wheel drive rig, it had the 231 t-case. I had to have it lengthened for my application, but then again, mine's got around 7" of lift and an 8.8" rear. It was only $15 for the shaft at the junkyard, and another $90 to get it lengthened & balanced.
sjkimmel99
NAXJA Forum User
- Location
- Phoenix, Az
Here's a table of ZJ front shafts, their closed length so you can look for one close to what you need and the OEM partnumber.
http://www.crownautomotive.net/catalog/axle/propeller_shafts2.html
http://www.crownautomotive.net/catalog/axle/propeller_shafts2.html
stoneattic
NAXJA Forum User
- Location
- Honey Brook, PA
If you have an AW4 you can probably just use an XJ shaft. If you have an AX-15 like me read here, but note in my case it was a H&T with the spicer flange adapter:
http://www.naxja.org/forum/showthread.php?t=926954
Certain ZJ used an odd flange/CV arrangement, they won't work.
http://www.naxja.org/forum/showthread.php?t=926954
Certain ZJ used an odd flange/CV arrangement, they won't work.
