rear driveshaft

2

2000bluexj

NAXJA Forum User

Location

Mass

• Aug 15, 2007

• #1

will a 94 rear driveshaft work in a 2000 with 3.5 inches of lift?

 

ROBZ95Xj

NAXJA Forum User

Location

Keene NH

• Aug 15, 2007

• #2

NO, 2 diffent driveshafts and 2 diffrent outputs on the tcases, you could try a tcase trop but best bet is to get a SYE

 

2

2000bluexj

NAXJA Forum User

Location

Mass

• Aug 15, 2007

• #3

could i just swap the out put yokes from mine to the 94 shaft?

 

ROBZ95Xj

NAXJA Forum User

Location

Keene NH

• Aug 15, 2007

• #4

2000bluexj said:

could i just swap the out put yokes from mine to the 94 shaft?

Click to expand...

that would require tearin down the tcase, if your gonna go through all that trouble you might as well do a sye

 

2

2000bluexj

NAXJA Forum User

Location

Mass

• Aug 15, 2007

• #5

if the u joints are the same, can i just install the shaft to the current yoke i have on the t case? the slip yoke is what i meant.

 

ROBZ95Xj

NAXJA Forum User

Location

Keene NH

• Aug 15, 2007

• #6

2000bluexj said:

if the u joints are the same, can i just install the shaft to the current yoke i have on the t case? the slip yoke is what i meant.

Click to expand...

no, cause you wouldnt have any slip joint

 

2

2000bluexj

NAXJA Forum User

Location

Mass

• Aug 15, 2007

• #7

the 94 shaft is only like an inch or 2 longer. wouldnt that put the slip yoke to what it was before the lift? like making up the distance the driveshaft has to go from yoke to axle? so basically i would have more splines engaged in the slip yoke. correct? or am i missing something