going full width, going to 3link the front, just needed a few dimensions and any recommendations on the design.
Need all dimensions marked with X if anyone has them. i would get them but am away from the jeep at the time, and need some steel estimates
and one more question im wondering what size tube would be best to use for the upper mount on the cross member, if i where to get a 7/8"x3/4" heim and some 7/16 wide standard mis spacers from ballistic that would put mounting width at 1.75, so i could use 2"x1/8" tubing, but im thinking that the 1/8" tubing will not be thick enough, what do yall think.
inspiration from vetteboy and timmay
Need all dimensions marked with X if anyone has them. i would get them but am away from the jeep at the time, and need some steel estimates
and one more question im wondering what size tube would be best to use for the upper mount on the cross member, if i where to get a 7/8"x3/4" heim and some 7/16 wide standard mis spacers from ballistic that would put mounting width at 1.75, so i could use 2"x1/8" tubing, but im thinking that the 1/8" tubing will not be thick enough, what do yall think.
inspiration from vetteboy and timmay