just tell me i'm stupid or help me figure this one out...
dana 30 wheel hub/ unit bearing is 27 spline the axle shaft that goes in it is 1.16" (can't find dimensions of the hole)
we seek a 27 spline 1.17 flange
if we cut the bearing and such off, knock out the studs and we are left with a simple splined flange. now redrill the flange to match the CV joint and wahla!!!!
or not....will it work?
scott
dana 30 wheel hub/ unit bearing is 27 spline the axle shaft that goes in it is 1.16" (can't find dimensions of the hole)
we seek a 27 spline 1.17 flange
if we cut the bearing and such off, knock out the studs and we are left with a simple splined flange. now redrill the flange to match the CV joint and wahla!!!!
or not....will it work?
scott