Dana 44 swap

This has been done over and over and over but its my first attempt at a helpfull write up so i wanted it to be easy. The First Problem I had was that with the larger u bolts, i would need A different Mounting plate. I took 2 off a waggy for 5 bucks. Next was my drive shaft. I had a custom c.v. shaft built when i put on a RE 4.5 inch kit on a year ago. I was hoping the shaft could slip enough to accomadate the longer dana 44 housing, but even all the way in, it was too long. Also I put the 2 degree shims on that came with the bolt kit. See any problems? Its my first time using them so im not very sure.






Waggy on the left, stock on the right


always learning something new