- Location
- Torrance, CA
When hoisting a 4.0 out what do you attach to?
-
Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.
Elementary Engine Hoisting Question
- Thread starter GSequoia
- Start date
CanMan
NAXJA Forum User
- Location
- Lake Tapps, WA
Id attach it to one or more of the head studs at the back of the head(drivers side) and to 2 of the bolt holes where the AC bracket is bolted to.
5-90
NAXJA Forum User
- Location
- Hammerspace
Ideally? I'd remove the head, and use head bolts on opposite corners (driver's rear and passenger front) to attach. The holes are threaded 1/2"-13.
Put fender washers on BOTH sides of the chain when you do.
5-90
Put fender washers on BOTH sides of the chain when you do.
5-90
Blue XJ
NAXJA Forum User
- Location
- Sterling Heights, Michigan
I took the manifolds off and used the rear most manifold bolt hole and for the front I used the bolt hole for the a/c bracket.
