2000xj4x4
NAXJA Forum User
- Location
- mandeville,La
i just cleaned my tb and now my jeep idles at 1500 rpm, anyone know how to correct this?
-
Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.
adjust idle??
- Thread starter 2000xj4x4
- Start date
- Location
- Harrisburg, NC
On a 2000, you can't really adjust the idle like you can on the older Renix motors.
I installed a new tps on mine back in December, as well as cleaned the TB while i had it apart. After putting everything back to gether I experienced the same high idle, at right around the same reading (1300-1500rpm). I took I restarted it and let it run for a minute or two about two or three times. Then I took it out and drove it about 3 or so miles, came back, and restarted it once more and the idle went back to normal. No more problems since.
The only logic I could come up with is that it needed time to "adjust" on it's own.
I installed a new tps on mine back in December, as well as cleaned the TB while i had it apart. After putting everything back to gether I experienced the same high idle, at right around the same reading (1300-1500rpm). I took I restarted it and let it run for a minute or two about two or three times. Then I took it out and drove it about 3 or so miles, came back, and restarted it once more and the idle went back to normal. No more problems since.
The only logic I could come up with is that it needed time to "adjust" on it's own.
old_man
NAXJA Forum User
- Location
- Loveland, Colorado
How did you clean the TB?
1985xjlaredo
NAXJA Forum User
- Location
- Kansas City
You might have a vacuum line disconnected?
Blaine B.
NAXJA Forum User
- Location
- Northwest Indiana
Did you remove the TPS at all or not?
