Only In A Jeep XJ
NAXJA Forum User
- Location
- Greenville, Texas
Was working on my new axles today and have run into a problem. I have a HP D30 out of a 86 XJ and I am replacing the C.V. Axle shafts with ones out of a 98 TJ. Now heres my problem. The grease seals in the hub are different. and the sleeve on the 86 is bigger than the 98 and on in different directions.
Now I've removed the seal rings cause I can not use them. But I don't want to leave the bearings exposed. So does any one know what seals need to be used?
This is the old C.V. Shaft
And this is the new shaft.
I placed the rings on there to give an idea of how they went.
Now I've removed the seal rings cause I can not use them. But I don't want to leave the bearings exposed. So does any one know what seals need to be used?
This is the old C.V. Shaft
And this is the new shaft.
I placed the rings on there to give an idea of how they went.