homebrew
NAXJA Forum User
- Location
- Bremerton, WA
Resently I had a 3 inch RC lift. On Saturday I installed two inch spacers to the RC coils which I figured gave me 4.5 inches of lift (SAG) anyway I also installed Tomken lower control arms that are currently adjusted out to 16.5 . I found a tech art.. that gave control arm length to lift height. It said that I needed 16.5 for the lowers and 15 for the uppers. For the uppers I was going to use a pair of RE arms, but fully compressed they are 15 inches already. Took a few measurements and the stock uppers are at 15. It drives fine no DW thank god. Just wondering if I should go ahead and install the upper arms or just leave it the way it is, I dont have any plans of lifting it any higher. TIA Paul