Jump This
Just another minion!
- Location
- Borrego Springs Ca.
How many times have we seen shock length questions here before???!!
But mine is a bit different (couldn't find answer in search)
I raised my lower shock mounts...but being the cheap bastid that I am, I wanted to reuse some 10" travel Bilstiens I had, sooooo, I cut holes and built a short shock tower to mount them.
The question I have is, at what point in the travel should I set the shocks at static?
That is to say, if I have 10" of travel, how much should I have for upper and lower travel (compression and droop.)
I have about 6" of lift and I run 33's with well cut wheel wells.
*I can't figure how to cycle the damn thing thru to measure for myself!*
Rick R:sunshine:
But mine is a bit different (couldn't find answer in search)
I raised my lower shock mounts...but being the cheap bastid that I am, I wanted to reuse some 10" travel Bilstiens I had, sooooo, I cut holes and built a short shock tower to mount them.
The question I have is, at what point in the travel should I set the shocks at static?
That is to say, if I have 10" of travel, how much should I have for upper and lower travel (compression and droop.)
I have about 6" of lift and I run 33's with well cut wheel wells.
*I can't figure how to cycle the damn thing thru to measure for myself!*
Rick R:sunshine: