MudDawg
NAXJA Member #728
- Location
- Central Florida
OK...I have searched till my eyeballs (all 4 of them) are gone whacky. Hopefully this will turn into a thread where there will be a definative answer as to exactly how to weld the tubes....rod material, prep work, technique, power supply (a/c, d/c, polarity, recommended amperage ranges,etc). I can't even find a definative answer as to what the center section material is.
There are plenty of references to welding the tubes, but they say "welded the tubes"...I'm doing the swap on my MJ mainly to get low cost disc brakes and SOA conversion. Please....no comparisons to 44's or 9in or other axles.
I want to do this ONCE and do it RIGHT...thanks guys.
There are plenty of references to welding the tubes, but they say "welded the tubes"...I'm doing the swap on my MJ mainly to get low cost disc brakes and SOA conversion. Please....no comparisons to 44's or 9in or other axles.
I want to do this ONCE and do it RIGHT...thanks guys.