XJ D44 housing end bolt pattern?

stoneattic · Dec 17, 2005

Does anyone know what the housing end bolt pattern is supposed to be on a XJ D44? I'm getting ready to mill/drill my ZJ caliper brackets to fit but I'm not sure of the pattern. I believe it's 2" x 3 5/16" centered about the axle shaft. Can anyone confirm or deny this?

TIA!

tysonxj · Dec 17, 2005

It was easier for me to drill the axle housing to match the brackets.

Just my .02$

stoneattic · Dec 17, 2005

It's easier for me to toss the brackets in the mill than my XJ

Plus if I screw up the brackets it's no big deal. If I screw up the D44 I'll be really unhappy

woody · Dec 17, 2005

stoneattic said:
Does anyone know what the housing end bolt pattern is supposed to be on a XJ D44? I'm getting ready to mill/drill my ZJ caliper brackets to fit but I'm not sure of the pattern. I believe it's 2" x 3 5/16" centered about the axle shaft. Can anyone confirm or deny this?

TIA!

I just went outside and measured my 89 MJ axle... 2" x 3 5/16"

stoneattic · Dec 17, 2005

woody said:
I just went outside and measured my 89 MJ axle... 2" x 3 5/16"

Awesome! Many thanks!

XJ D44 housing end bolt pattern?

stoneattic

NAXJA Forum User

tysonxj

NAXJA Forum User

stoneattic

NAXJA Forum User

woody

NAXJA Forum User

stoneattic

NAXJA Forum User

Similar threads