New To The Site, Just Did A Rear Brake Job And Found That My Left Side Sxle Was Leaking. I Understand To Get An Axle Puller And Pull The Axle, How Difficult Is The Job To Replace The Seals. Need As Much Help And Advice As Possible. What Are The Best Type Of Seals To Use. Thanks
-
Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.
Help Leaking D44 Rear Axle
- Thread starter Elwood
- Start date
- Location
- NC Sandhills
You may not need the axle puller... just flip the drum over and thread 3 lugs on... use it as a slide hammer.
I think you'll need to have the bearing on the shaft pulled off (the outboard seal goes between the bearing and the plate.) There is also an inner tube seal just inside of the bearing, so you'll need some sort of snatcher to extract it, and a driver to install a fresh one.
I think you'll need to have the bearing on the shaft pulled off (the outboard seal goes between the bearing and the plate.) There is also an inner tube seal just inside of the bearing, so you'll need some sort of snatcher to extract it, and a driver to install a fresh one.
