i wanted to get my friends full size bronco with a rebuilt 302 engine and new transmisssion in it they both have less than 500 miles on them. so the question is will this fit in my 93 xj with a straight six 4.0. if its possible what specific things will i need to make it fit like a ford adator or anything?
-
Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.
will it fit
- Thread starter MattsXj
- Start date
sintax
NAXJA Forum User
- Location
- Corona, CA
long story short, yes it will fit just fine.
there is no bell housing you can use to connect your AW4 to the 302. So unless you have a AX15 you'll be needing to swap the tranny too, and you might as well swap the T-case in too.
As for the motor fitting, it will fit just fine, you will need to make engine mounts though. This is not a bolt in thing.
there is no bell housing you can use to connect your AW4 to the 302. So unless you have a AX15 you'll be needing to swap the tranny too, and you might as well swap the T-case in too.
As for the motor fitting, it will fit just fine, you will need to make engine mounts though. This is not a bolt in thing.
