ACOS (attn: Mark Hinkley)

i'm setting up for the install today and was wondering if there is another measurment (metric vs standard) size tap i could look for. i can't find one that reads 10mm x 1.5p. i'm assuming the 1.5p has something to do with the thread count, but none of the taps i have seen list this on their packaging. should i just assume its the correct size with any 10mm tap? excuse my ignorance, but i obviously dont want to screw this part of the install up.

The 1.5 is the pitch,if thats the hardware you need then thats the tap you need!