Need D44/SYE yoke help

I am ordering the new shaft for my AA SYE and i fingered that now would be the time
to upgrade from 1310 to 1350 if possible.
After reading a few old posts here, it looks like it can be done.
Before i start measuring for the new shaft i want to have the yoke/u-joint issue hammered out.
Anyone know 1.can it be done
2.is it worth it
3. Where can i find the 1350 yoke for my D44

Got my yoke for my D-44 from tom woods. was less than 50 bucks. Right part at the right time. Well worth it. give them a call.

So you are going to run two 1310's in the front and in the rear one 1310 and a 1350. I don't think you are gaining anything and it aslo eliminates your ability to use your fron drive shaft as a spare.


Ya, I'm trolling your thread again, I hope it isn't too lastara for you!