VegasAnthony
NAXJA Forum User
- Location
- Las Vegas
just wonderwhere i could get some heavy duty hinges to fab a swingout tire carrier on a custom bumper??
-
Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.
where to get hinges to fab a swing out tire carrier
- Thread starter VegasAnthony
- Start date
ChuckD
NAXJA Forum User
- Location
- Kerman, CA
Contact Zion
[email protected]
He has made many versions of his rear bumper. He might be able to help. He posts as ZPD.
[email protected]
He has made many versions of his rear bumper. He might be able to help. He posts as ZPD.
Maximus
NAXJA Forum User
- Location
- Bakersfield, CA
I would suggest that you make the hinge also using an oil impregnated bronze bushing or an actual sealed roller bearing that has flanges. I feel anything you can buy off the shelf will not do what you want, I may be wrong though.
- Location
- Antioch, CA
hinges
I saw a guy who used a front wheel bearing/hub assy from the front of his TJ as the hinge. Not sure what your design is but it might work. Good for a spare part on the trail too.
I saw a guy who used a front wheel bearing/hub assy from the front of his TJ as the hinge. Not sure what your design is but it might work. Good for a spare part on the trail too.
G
Guest
Guest
Rockstomper
http://www.rockstomper.com/catalog/pieces/hinge.htm
http://www.rockstomper.com/catalog/pieces/hinge.htm
Stoney
NAXJA Forum User
- Location
- Citrus Heights
just use some rubber bushings and a bolt.
G
Guest
Guest
swinging tire
ive seen a trailer axle stub ( easily avilable @ any trailer store)
some bearings to match, a short piece of pipe to fit over bearings & a dust cover
ive seen a trailer axle stub ( easily avilable @ any trailer store)
some bearings to match, a short piece of pipe to fit over bearings & a dust cover
