Jeepster4wd
NAXJA Forum User
- Location
- socal
hey guys does anyone know what size bolts i need to hold a 4.0 onto an engine stand i use to have some but they some how got lost.
-
Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.
engine bolts
- Thread starter Jeepster4wd
- Start date
5-90
NAXJA Forum User
- Location
- Hammerspace
The uppers are 3/8"-16, the lowers are 7/16", and I believe are threaded 14tpi (whichever the coarse thread is for that size...)
HTH
5-90
HTH
5-90
spazegun2213
NAXJA Forum User
- Location
- NoVa or terre haute IN
haha... had the same problems a little while ago
here is the link
look all the way at the bottom, that should do it. I got my stroker project on a stand now.
good luck
here is the link
look all the way at the bottom, that should do it. I got my stroker project on a stand now.
good luck
Jeepster4wd
NAXJA Forum User
- Location
- socal
thanks guys.
