PDA

View Full Version : Question for guys with Hella E-Codes or Vision Plus...


nosajwp
November 17th, 2004, 06:24
Ok guys, I just sold my Hella E-Codes because I didn't like the pattern they produced. When the lows were adjusted properly, the highs were up in the trees, and when the highs were good, the lows stopped right in front of the Jeep. Do any of you guys have this problem?

Could it have just been a problem with either my housings or the bulbs I had? They were of really nice build quality, and if they high beams hadn't been so high when the lows were adjusted, I would have kept them.

ChiXJeff
November 17th, 2004, 08:09
I've got E-codes with Hella 55/100 bulbs. Nice pattern. Lows light up the immediate vicinity, the highs shine down the road. Good cutoff, I don't get brighted by other drivers either.

What bulbs did you use?

nosajwp
November 17th, 2004, 09:34
Hella 55/60 bulbs. The lows were nice, and the highs would have been nice if they were closer to the road surface instead of up in the trees.

djinn
November 17th, 2004, 11:26
I've got E-codes with Hella 55/100 bulbs. Nice pattern. Lows light up the immediate vicinity, the highs shine down the road. Good cutoff, I don't get brighted by other drivers either.


I've got the E-codes with Hella 80/100 bulbs. I agree with ChiXJeff - very nice pattern. I had no troubles aiming them either - both lows and highs are right where they should be. It does take a little getting used to - where there is light, there is a LOT of light, and where there is none (like, outside the pattern), it is DARK - with a very sharp cutoff.

Handlebars
November 17th, 2004, 12:04
I've got the E-codes with Hella 80/100 bulbs. I agree with ChiXJeff - very nice pattern. I had no troubles aiming them either - both lows and highs are right where they should be. It does take a little getting used to - where there is light, there is a LOT of light, and where there is none (like, outside the pattern), it is DARK - with a very sharp cutoff.
Ditto.

fasty
November 17th, 2004, 15:21
No problem here, I am using Hella E-Code with Narva 90/100 watts. Sure it lit everywhere up!