Metal Replacement?

Hiaboo · Nov 11, 2004

I have a few rust spots (I searched) but I havent found the answer I was looking for--- the ga. of the sheet metal I should use for the rusted spots.. one's on the rockers, (a quarter sized hole, cleaned out), and then the interior, rear wheel wells, on the base..... I'm thinking 16 for the outside, and a 18 for the inside (so it can be conformed to the curves?)

TIA

Beezil · Nov 11, 2004

Hiaboo said:
I have a few rust spots (I searched) but I havent found the answer I was looking for--- the ga. of the sheet metal I should use for the rusted spots.. one's on the rockers, (a quarter sized hole, cleaned out), and then the interior, rear wheel wells, on the base..... I'm thinking 16 for the outside, and a 18 for the inside (so it can be conformed to the curves?)

TIA

I think you are on target for your thicknesses.

I'd use about the same thing.

Metal Replacement?

Hiaboo

NAXJA Forum User

Beezil

Member #Nay

Similar threads