- Location
- NE Indiana
any ever put discs on an eaton rear axle...formerley a dualie axle????
i know this is probably more of a por question and i'll probably end up over there, but i was just curious if anyone had done em...
or if anyone had trimmed up an eaton rear axle for more clearance....
and...........
i have a set of d60 outters that i could use insead of the eaton outters...but the bearings are too small, anyone know if i could put the same outside diamter bearings in them with bigger inner diameter on the bearings....???
mac 'trying to learn from others mistakes' gyvr
i know this is probably more of a por question and i'll probably end up over there, but i was just curious if anyone had done em...
or if anyone had trimmed up an eaton rear axle for more clearance....
and...........
i have a set of d60 outters that i could use insead of the eaton outters...but the bearings are too small, anyone know if i could put the same outside diamter bearings in them with bigger inner diameter on the bearings....???
mac 'trying to learn from others mistakes' gyvr
