ARB wiring help needed ASAP

I've been working feverishly on getting my on-board air system installed, but I've run into another problem. I have no clue how to wire up the switches for the lockers, and how to wire the switches to the solenoids.

The ARB switches have five spades on them. On one end, there are three spades (a pair next to one another and one below and on the right). On the other end is another pair, next to one another. There are no markings on the switch to indicate what each spade is for.

So help me out.
Which one or two of these spades goes to the solenoid - and to which of the two unmarked female connectors on the solenoid? (or does it matter?)
What about each of the others?

Anyone who's familiar with these and can explain it to me in the simplest of terms? A diagram would be great, if anyone has one.
TIA

my installation manual reads: on the switch- #8: ground; #2: ignition (power) source; #3: to solenoid; #6: to dashboard illumination; #7: ground

at the solenoid- one wire connects to spade #3 on the switch, the other wire is ground.

even better: http://www.ih8mud.com/tech/arb-inst.pdf (go to page 30) it's a toyota installation guide, but the electrical is all the same.

HTH-
Chuck

a manual!!
THAT would have been helpful!

Thanx a ton.