PDA

View Full Version : In the middle of a locker install....Need Help!


BrianC
April 17th, 2004, 12:39
How do I get the carrier out of a Dana 44? I have the bearing caps off and axles out but it won't budge.

ChuckD
April 17th, 2004, 12:41
Take a rag and put it in between the ring and pinion. Turn the pinion and the carrier will pop out.

BrianC
April 17th, 2004, 13:01
I tried the rag trick, still not out. I can only turn the pinion a little bit.

Goatman
April 17th, 2004, 13:09
Crank it, baby!!!

:D

ChuckD
April 17th, 2004, 13:09
Put a pipe wrench on that flange! :D

ChuckD
April 17th, 2004, 13:10
You did get the shafts out right? :D

BrianC
April 17th, 2004, 13:22
axle shafts are out. 1 shreaded rag. I guess I need to go heavier duty

BrianC
April 17th, 2004, 13:39
still nothing. Can I unbolt the ring gear in the dif so I can get the pinion shaft out that way?

Inisadow
April 17th, 2004, 13:59
Take some rope loop it around carrier then attach it to a comealong and attach the other end of the come along to the bumper or hitch and just crank it out tell it pops out and watch your hands both times I helped my friend do it it shot out onto the ground.

BrianC
April 17th, 2004, 14:02
Fina :greensmok ly got it out. Thanks guys!!!

poomba
April 17th, 2004, 14:12
Take some rope loop it around carrier then attach it to a comealong and attach the other end of the come along to the bumper or hitch and just crank it out tell it pops out and watch your hands both times I helped my friend do it it shot out onto the ground.

Just had a vision of ring/pinion braces....