front 44 upper arm mounts?

this may be a newb question, but i searched a good bit and only found a few topics. looking for some pics and advice on the upper contol arm mounts for a waggy 44. im a little confused as far as welding to cast is concerned, wondered what other options there were. thanks for any info that you could give.

Mark

I used the RE bridge on my HP44. I didn't like the idea of welding to the cast housing.

I used a Ford HP D44 housing, but you can check out my long winded article on http://www.madxj.com. I built a bridge similar to the RE item. Jeff

useless said:

I used the RE bridge on my HP44. I didn't like the idea of welding to the cast housing.

Click to expand...

Hey, that looks like a URF built axle!

CRASH

hey jeff, thanks for the article. i really like the gussets on the passenger side upper arm mount. so im assuming a "bridge" over the pumpkin is the best way? thanks guys.

mark