Hey guys, my question is I have a 89 Jeep XJ with 8 inches of lift, a NP242, and Rubicon Expresses Hack and tap slip yoke eliminator kit. Anybody run the RE hack and tap and make their own rear shaft? My primary shaft is a Woody. What do people use as a backup and where did they get their ends for the shaft? I'm talking about the CV part and the mounting flange. I was tempted to just order another shaft as a spare, but I don't want to fork out another 300 bucks if I don't need to.
-
Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.
Idea's for spare rear driveshafts
- Thread starter atowley
- Start date
- Location
- San Bruno, CA.
I carry my old Woods shaft as a spare and have a High Angle on as a primary.
If you want to build your own you can get mounting flanges, CVs, and other parts at any place that sells Spicer or Neapco parts.
Jes
If you want to build your own you can get mounting flanges, CVs, and other parts at any place that sells Spicer or Neapco parts.
Jes
