- Location
- Maurertown,Va.
Pulling apart my D44 to clean up and re-gear.The roll pin that holds the cross shaft has got me stopped.
My 3/16 pin punch is not long enough to drive the pin out before the fat part of the punch hits the cap.
Is there an extra long punch that you use or did you turn down the body on a regular punch to make it reach.
My plan is to take it to work and turn it down.
Wayne :
My 3/16 pin punch is not long enough to drive the pin out before the fat part of the punch hits the cap.
Is there an extra long punch that you use or did you turn down the body on a regular punch to make it reach.
My plan is to take it to work and turn it down.
Wayne :
