Safari Ary
NAXJA Forum User
- Location
- Virginia Beach, VA
Well, is a piece of 3/8" x 6" flat bar thick enough to use as a flat x-member?? I've got a piece of it in my garage is the only reason I'm trying to avoid other materials. I don't plan on putting any stiffening bends into it, or anything like that, and it might be reduced to 4" wide for exhaust clearances. So what do you think?? Will it be thick enough or will it flex?? I know ORGS's x-member is 1/4" 2x4, which is why I'm questioning 3/8" flat bar. Thanks for any input. Peace
Ary
P.S. Eventually gonna build a T-case skid off of this, so it should be able to take blows, not just hold up the tranny.
Ary
P.S. Eventually gonna build a T-case skid off of this, so it should be able to take blows, not just hold up the tranny.