What degree shims for 8" of lift and sye

B

BIG98XJ

NAXJA Forum User

Location

Duluth, Ga

• Nov 10, 2003

• #1

So I got the Hack n tap in along with the 33 1/2" CV driveshaft, what shims do I need now?

 

D

dennisuello

NAXJA Forum User

Location

Reno, Nevada

• Nov 10, 2003

• #2

install it all, them measure the pinion angle and driveshaft angle, then figure out what degree shims you need to make them the same. shoot for pinion angle being 1 degree less than driveshaft angle.

 

B

BIG98XJ

NAXJA Forum User

Location

Duluth, Ga

• Nov 10, 2003

• #3

Got it all in, guess i`ll get to measuring!

 

H

hpi_jeep

NAXJA Forum User

Location

Mid-Missouri

• Nov 11, 2003

• #4

dang, at these angles i think i'll be better of just cutting off spring perches and welding them on about 40* from where they are...