1998 XJ 4.0
P0320 code - crank position sensor signal lost
Jeep runs great. After a longer drive if it gets good and warmed up, if you shut it down for 20 minutes to about an hour or so, it will then crank but not fire. Turn ignition off, wait even just 5 seconds, fires right up and again runs great.
Dealer CPS did not resolve issue. Swapped CPS with a buddy did not resolve issue (and buddy didn't inherit issue). Pulled apart loom wires all look great and volt/ohm check comes back great.
Anyone else have this issue and find a fix? Kinda left scratching my head on this one.
P0320 code - crank position sensor signal lost
Jeep runs great. After a longer drive if it gets good and warmed up, if you shut it down for 20 minutes to about an hour or so, it will then crank but not fire. Turn ignition off, wait even just 5 seconds, fires right up and again runs great.
Dealer CPS did not resolve issue. Swapped CPS with a buddy did not resolve issue (and buddy didn't inherit issue). Pulled apart loom wires all look great and volt/ohm check comes back great.
Anyone else have this issue and find a fix? Kinda left scratching my head on this one.