-
Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.
Is Anyone using a front driveshaft with two double cardan joints?
- Thread starter Desert4x4
- Start date
What is your current caster? I would cut and turn Cs if it was that bad.
Sent from my iPhone using Tapatalk
RCP Phx
NAXJA Forum User
- Location
- Phoenix,Az
What's your caster at now? I have a 2000 so it's a LP at 5.5", I have ran about 3* caster for over 16 yrs with no issue!
- Location
- Hammertown, USA
I've seen people run them, but there's so much spinning mass its almost impossible to not get vibrations from out of balance, and they end up getting rid of it again.
RattyXJ
NAXJA Forum User
- Location
- Nashville TN
I'm running one in the rear. I have some low speed vibration but nothing unmanageable. At interstate speed its smooth. I am too at "5.5" of Rubicon Express lift.
RCP Phx
NAXJA Forum User
- Location
- Phoenix,Az
RattyXJ
NAXJA Forum User
- Location
- Nashville TN
I think he's speaking of something like this!
I am definitely not running that. Sorry to chime in.
