Trans Tunnel Bolts?

Well, I'm going to have to replace a large section of the Trans tunnel on my renix... because of how rusted it is. I'm assuming these 4 bolts are either the 4wd shift linkage bolts or....?? Basically I need to know what the notch on the left side is for in between them as well. I'll be completely re-fabricating this side of it.

Sent from my VS990 using Tapatalk

Those bolts support the Transfercase shift linkage. The bulge is to clear the Transfercase itself.

Dragonlich1961 said:

Those bolts support the Transfercase shift linkage. The bulge is to clear the Transfercase itself.

Click to expand...

Ok, thanks for that. I guess I need to fabricate a new patch for each row of bolts and then just re-align the fit. I'm a little apprehensive of the best way to go about this. Any ideas?

Sent from my VS990 using Tapatalk

If I were you, I'd get rid of the shitty oem bolts/bracket/linkage and pickup one (linkage) from boostwerks.

notamos said:

If I were you, I'd get rid of the shitty oem bolts/bracket/linkage and pickup one (linkage) from boostwerks.

Click to expand...

Not a bad idea if I say so myself

Sent from my VS990 using Tapatalk