Has anyone ran 35'some on 2014 Rubicon wheels

K

kippo1

NAXJA Forum User

Location

Alabama

• May 9, 2016

• #1

Have 2014 Rubicon wheels but found a set of Nitto Terra Grappler G2 315 70 17r. Just trying to see if anyone has ran this size on factory Rubicon wheels.

 

cal

NAXJA Forum User

NAXJA Member

Location

Hammertown, USA

• May 9, 2016

• #2

Yes. On a JK Rubicon.

Eventually ended up buying wider wheels.

 

K

kippo1

NAXJA Forum User

Location

Alabama

• May 9, 2016

• #3

I'm running 1.75 spacer adapters I just didn't know if they would bulge to much and cause rubbing.

 

C

cwyman6

NAXJA Forum User

Location

socal

• May 9, 2016

• #4

They will be fine on that rim. Need at least 1-2 in of bump. Lift should match bumpstop

 

VAhasnoWAVES

NAXJA Forum User

Location

Lake City, Mi

• May 9, 2016

• #5

its not hard to figure out... whats the back spacing on your wheels? how wide are your spacers? so now what is your new back spacing? what do people usually run for back spacing on 35s?

youll be fine for the most part. but expect to rub... how much depends on your lift, how much sheet metal you have cut, and how far you are bump stopped.

 

K

kippo1

NAXJA Forum User

Location

Alabama

• May 9, 2016

• #6

4.5 lift plus 2 in coil spacers, extended shackles and relocations installed along with cut out flat flares.

 

AlphaQup

NAXJA Forum User

Location

Concord CA

• May 12, 2016

• #7

If you end up at 3.75" of back spacing you should be ok if you have extended bump stops and 3" or 4" lower bump pads.


Sent from my iPhone using Tapatalk