97+ D30 Shafts in 93 D30?

No ABS open carrier. Just looking to upgrade my u-joints without spending almost more than I did on the jeep itself. Was thinking of grabbing ZJ shafts but don't want the CV junk. Thanks

Yes, normal 97+ XJ D30 shafts will work.

Thanks. Wasn't sure since someone had wrote about some being too long/short.

Well I have my stock 2000 XJ LP D30 shafts in an 1989 XJ limited HP D30 housing ... So gonna have to say length never changed.

X/Y/Z/T/MJ D30 axles are pretty much all the same.

High pinion and low pinion (shafts are still interchangeable), bearings/brake sets are relatively interchangeable ... unless you have a 1989 or older with different knuckles and of course CAD and not CAD but I a 93XJ should not have the CAD. Grab a junkyard set of shafts from a newer XJ or a TJ and put some 5-760X joints in and call it a day!