austinandtina
NAXJA Forum User
- Location
- illinois
Hey guys bought my xj a month or so ago and thought it seemed pretty solid....
-
Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.
94 xj build
- Thread starter austinandtina
- Start date
austinandtina
NAXJA Forum User
- Location
- illinois
Until I found out floorboards were gone
After pic
After pic
austinandtina
NAXJA Forum User
- Location
- illinois
After that was done I was on my way to work Thursday and made it 10 miles and was still freezing my butt off. Looked down and the temp was at about 230
put new 180 degree thermo In it last night let the rtv seal up over night and today worked fine. Other than my antifreeze looking like a white russian. Which on that I don't belive it's a head gasket problem no white smoke or bubbles in radiator. Just have to flush it and see.
put new 180 degree thermo In it last night let the rtv seal up over night and today worked fine. Other than my antifreeze looking like a white russian. Which on that I don't belive it's a head gasket problem no white smoke or bubbles in radiator. Just have to flush it and see.austinandtina
NAXJA Forum User
- Location
- illinois
So now I'm sitting on 245 75 16 at3 lot of rub. Thinking about heading out there right now and cutting out the fender support bracket and taking of the front bumper caps and lip
austinandtina
NAXJA Forum User
- Location
- illinois
Well that was Interesting I went out pulled the lip off and cut the fenders about where the caps top line was. And cut my bumper from the top corner down at a angle to the first bumper bracket. Then I thought to myself I might as well pull the rear caps off too. Grr rusted out on the corners underneath the caps. I tried my first fiberglass job looks like hell but it's done. What do you guys think about just cutting my rear bumper down about 4 to 5 inches on each side?
austinandtina
NAXJA Forum User
- Location
- illinois
Headgasket = gone
lukc22
NAXJA Forum User
- Location
- central texas
How did you do your floors? They dont look welded.... I have a 94 and am looking at the same issue...
austinandtina
NAXJA Forum User
- Location
- illinois
They are welded still have to seal the edges
lukc22
NAXJA Forum User
- Location
- central texas
What metal did u use??
lukc22
NAXJA Forum User
- Location
- central texas
Now i see the welder in the background... i was looking at the drivers side floor...
austinandtina
NAXJA Forum User
- Location
- illinois
Lol
austinandtina
NAXJA Forum User
- Location
- illinois
Okay guys got the jeeps headgasket replaced and most of its quirks worked out still have some rust to attend to like rear wheel wells are pretty rotted and rockers etc. But here are some photos of just a few min ago me playing in snow
