clayton long arm install ?

Santa came last week. Clayton off road 4.5 in long arm lift kit for my 99 xj. My question is when I go to bolt up my upper control arm to the axle the bolt is quit a bit smaller than the sleeve in the oem size bushing, but the bolt supplied by clayton is a snug fit going through just the control arm itself. What do I do? Seems pretty important to me that their not be an excessive amount of play between the two. Thanks for the help.

Drill out the control arm and run the largest bolt you can fit in the upper. Factory is a 10mm, but I usually drill them out to 7/16 for added strength.

I am over at Chachis, it turned out to just be bad bushings.
The kit fits fine now.