-
Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.
How tight do I make the joints on the Boostwerks shackles?
- Thread starter xriide
- Start date
yossarian19
NAXJA Forum User
- Location
- Grass Valley, CA
IIRC it's a polyurethane race in the johnny joint boostwerks is using. I would spin it in gently until the nut is touching the race, tighten to the next set screw & grease it. If you make it too tight, the grease won't get in between the ball and race.
I didn't realize they were on here. But I will ask and suggest maybe listing on their site.
- Location
- Virginia City, NV
Isnt it just a ballistic fab joint. Why not follow there spec.
http://www.ballisticfabrication.com/263-Heavy-Duty-Ballistic-Joint_p_1226.html
I can't see an install on there? But I have been known to miss things before.
- Location
- Virginia City, NV
Your right i cant seem to find any install on there site. Kind of lame.
On a few other forums i saw what was posted above. Snug, then tighten to the next locking notch.
On a few other forums i saw what was posted above. Snug, then tighten to the next locking notch.