AJ SuperSliders Hardware list

Hi guys.

Ive bought a set of AJ supersliders secondhand for my xj but had no hardware included. Original owner said he lost them :smoker:

Anyway Id like to take a list down to my local bolt supplier and get the hole lot in stainless steel.

Does anyone have a list of the hardware I need?

Thanks

Luke

The bolts that self-tap into the frame rail are 3/8 inch. IIRC the drill bit recommended for the holes these bolts screw into is just a hair smaller diameter...like maybe 1/32 inch smaller. I don't think the size of the bolts that go into the pinch seam is critical. You use washers on them to get a tight connection. Not sure about the size of the bolt that goes through the rear spring hanger but it uses washer too, so as long as it goes through the hole and you have a couple washers you should be OK.

Call or email AJ's when in doubt...

You are aware that stainless is fairly weak when compared to regular bolts?

souske said:

You are aware that stainless is fairly weak when compared to regular bolts?

Click to expand...

Still stronger than the unibody they are bolted into.

rockclimber said:

Still stronger than the unibody they are bolted into.

Click to expand...

That was my thoughts.... and no rust.

Also I did email aj but haven't had a reply yet

Last time I emailed which was not long ago he/they took a few days but they did get back to me...